When removing old receptacles, note the color of the wires. There should be 2 colors; black and white. Often, there is a third wire, a bare ground wire. You will most likely find that there are 1, 2, or even 3 black and white wires at each receptacle. Connect the black wires to one side of the receptacle, and the white wires on the other side. Most often, 2 or 3 wires of each color are connected to the screws on either side of the devise. There are 2 screws on each side. If there are 2 white wires, then place each wire under one screw. Same on the black side. If there are 3 of each color, often times, the third wire will be doubled up under one of the screws.
Turn off the Power: Whatever you do, don't skip this step! Head on down to the basement and turn off the circuit that leads to the part of the house you're working on. It may not be a bad idea to put some tape over that circuit for the time being so no one turns it back on while you're working. This step is crucial in making sure you don't get hurt.
1. Make sure your switches and outlets are setup for switch plates. Many older homes might not be setup to accept newer style wall covers. If this is the case, you might have to replace the receptacles. But most people should not run into that situation.
2. Determine your color pattern in the room you are changing out the plates. This will help you integrate your plates into your design and keeps them from not matching. It is easier if you determine your rooms color scheme beforehand and then match buy the plates as needed.
3. Decide on the type of switch plate you are going to use. You can find them made out of almost any material such as metal, plastic, wood, ceramic, and stone. Certain types of wall covers will go with a certain design theme in your room or home.
4. Determine how many plates you need in total. This might seem like common sense, but I have seen many people rushing out looking for switch plates and then realizing that they forgot to count how many they need.
So if you want to update your homes decor by using switch plates,Please go to http://www.wlpipeline.com. make sure you follow these simple steps to make the whole process easier and more enjoyable.